Description
Triconex 3624 Supervised Digital Output Module
Product Title
Triconex 3624 | 16-Channel TMR Supervised Digital Output Module for Tricon SIS Safety Instrumented System
Product Description
The Triconex 3624 is a triple modular redundant (TMR) supervised digital output module designed for Tricon safety instrumented systems. It delivers 16 commoned-return 24VDC digital outputs to drive safety-critical field actuators, valves and solenoids. Built with 2-out-of-3 voting architecture, the module maintains safe operation upon a single internal fault. Integrated loop supervision continuously monitors each channel for open load, short circuit and field power loss, reporting diagnostic alarms to the host controller. This module supports hot-swap replacement on compatible chassis without system shutdown, minimizing maintenance downtime. It holds SIL3 certification under IEC 61508 and is widely deployed for safety shutdown, burner management and critical interlock applications in hazardous process industries.
Technical Specifications
| Item | Parameter |
|---|---|
| Brand | Triconex (Schneider Electric / Invensys) |
| Model | 3624 |
| Module Type | Supervised Digital Output (SDO) |
| Channel Count | 16 channels, commoned return |
| Nominal Field Voltage | 24 VDC |
| Operating Field Voltage | 16 ~ 30 VDC; max 36 VDC |
| Continuous Current | 0.7 A per channel |
| Surge Current | 4.8 A for 10 ms |
| Minimum Load Current | 30 mA (for supervision) |
| On-State Voltage Drop | <1.5 VDC typical |
| Channel Isolation | 1500 VDC between logic side and field circuit |
| Architecture | TMR, 2oo3 fault-tolerant voting |
| Diagnostics | Open load, short circuit, field power loss, voter mismatch |
| Logic Power | Supplied via Tricon backplane |
| Power Consumption | <10 W |
| Operating Temperature | -40°C ~ +70°C |
| Storage Temperature | -40°C ~ +85°C |
| Humidity | 5% ~ 95% non-condensing |
| Safety Certification | SIL3 (IEC61508), UL, CE, ATEX |
| Hot Swap | Supported on Tricon v10+ chassis |
| Enclosure Rating | IP20 (chassis mounted) |
Compatibility & Installation Pitfalls
Compatibility
- Host Chassis: Tricon 3000 series TMR SIS chassis
- Configuration Software: TriStation 1131 v3.x and above
- Termination Panel: 9662-610 16-ch 24VDC commoned ETP
- Firmware: Main processor firmware must match 3624 revision baseline
- Not compatible: Trident, Tri-GP or early Tricon CX platforms without formal engineering assessment
Critical Installation Traps
- Mechanical keying mismatch: The 3624 has dedicated slot key profile. Never force the module into mismatched slot; it can crack backplane traces and destroy the card.
- Minimum load requirement: Each channel needs ≥30mA load. Low-current solenoids trigger false “LOAD OPEN” alarms. Install dummy load resistors on unused or low-draw points.
- Overvoltage damage: Field voltage exceeding 33VDC will damage output driver transistors. Validate field power before connecting wiring.
- Hot-swap limitation: Hot replacement only works for Tricon v10+ racks. Performing hot swap on older chassis may trigger bus faults and system alarms.
- ESD hazard: Output semiconductor circuits are sensitive to electrostatic discharge. Wear grounded anti-static wristband; avoid touching gold edge connectors.
- Wiring short-circuit: Field short on any channel activates built-in self-protection, but repeated short events degrade module lifetime. Inspect cable insulation before commissioning.
- Ground potential difference: Large ground offset between chassis and field devices creates common-mode noise and false diagnostic trips. Separate protective earth and signal ground properly.
Standard Operating Procedure (SOP)
- Pre-Installation Inspection Fully de-energize the chassis. Inspect module for physical damage, bent connectors or corrosion. Verify chassis firmware, TriStation version and ETP model compatibility. Prepare ESD protection kit.
- Module Insertion Match mechanical slot keying. Slide module into the I/O slot until fully seated against backplane. Lock both latches to secure the card.
- Field Termination Wiring Route 24VDC field cables to 9662-610 termination panel. Perform continuity and insulation resistance test. Fit dummy loads on channels with low-current actuators or unused points. Confirm no short-circuit between wires or to earth.
- Software Configuration Open TriStation 1131. Add 3624 module to hardware tree, configure channel supervision parameters. Download project to Tricon main processor.
- Power-Up & Commissioning Energize chassis power. Wait for module self-test. Check LED indicators: PASS = healthy, FAULT = alarm. Force each channel ON/OFF and validate actuator action and diagnostic response.
- Online Operation & Diagnostics Monitor module health, channel open/short alarms and voter disagreement flags via TriStation or HMI. Keep diagnostic logs for proof test and SIL audit.
- Hot-Swap / Replacement Procedure Confirm chassis supports hot swap. LOTO field circuit for the faulty channel. Release locking levers and pull module straight out. Insert spare 3624, latch firmly. The new module synchronizes state automatically; no full project download required. Recheck channel diagnostics after replacement.
Application Scenarios
- Oil & Gas ESD Emergency Shutdown Systems
- Petrochemical & Refinery Safety Interlock Solenoid Control
- Fire & Gas (F&G) Suppression Valve Actuation
- Power Plant Boiler / Turbine Trip Protection
- Chemical SIL3 Safety Instrumented Loops
- Burner Management System (BMS)
- LNG Terminal Safety Valve Control
- Pipeline Emergency Isolation Valve Control
Supporting Components
- Tricon TMR Main Chassis
- Tricon Backplane
- 9662-610 External Termination Panel (ETP)
- TriStation 1131 Configuration Software
- Tricon Main Processor Module
- Tricon Chassis Power Supply
- Ribbon Harness between ETP and I/O Module
- Dummy Load Resistors (470Ω,10W) for low-current channels
- Anti-static wristband & ESD work mat
- 24VDC Calibration Power Source for loop testing
Related Model Recommendations (10 Models)
- 3601E: TMR supervised digital output module
- 3623: High-density TMR digital output module
- 3625: Tricon TMR relay output module
- 3501E: 16-ch isolated TMR digital input
- 3504E: 64-ch non-isolated TMR digital input
- 3704E: 64-ch TMR high density analog input
- 3721: TMR analog output module
- 3009: Tricon main processor module
- 4119A: Enhanced Intelligent Communication Module
- 3664: High-density unsupervised digital output



